Khetan Group

logo

How to Install a Drawer channel

1. Mark the Placement of the Slides

Measuring from the inside floor of the cabinet, mark a height of 8¼ inches near the front and back of each sidewall. Using the marks and a straightedge, draw a level line across the wall on each inside wall of the cabinet. Make a mark on each line that’s 7/8 inch from the front edge of the cabinet. This allows room for the thickness of the drawer front plus a 1/8-inch inset.

2. Position the Slides

 How-to-Install-Drawer-Slides---Step-2-copy

Align the bottom edge of the first slide above the line, as shown. Position the front edge of the slide behind the mark near the face of the cabinet.

3. Install the Slides

 Holding the slide firmly in place, push the extension forward until both sets of screw holes are visible. Using a drill/driver, drill shallow pilot holes in one screw hole near the front and back of the slide. Using the screws provided, mount the slide to the inside of the cabinet. Repeat steps 2 and 3 to mount the second drawer slide on the opposite side of the cabinet.

How-to-Install-Drawer-Slides---Step-3-copy

4. Mark the Drawer Sides 

Using a tape measure, mark the centre of the height of the drawer box on its outer sidewalls. (Note: this drawer is shown without the drawer face, which will be installed at the end of this tutorial.) Using a straightedge, mark a horizontal line along the outside of the drawer box on each side.

How-to-Install-Drawer-Slides---Step-5

5. Position the Slide Extension

Remove the detachable section of each drawer slide, and place it on the corresponding drawer side. Position the slides so that they are centred on their corresponding line and flush with the face of the drawer box, as shown.

How-to-Install-Drawer-Slides---Step-6-copy

6. Attach the Slides to the Drawer 

Using a drill/driver and the screws provided with the drawer slides, mount the slide to the drawer.

How-to-Install-Drawer-Slides---Step-7-copy

7. Insert the Drawer

Hold the drawer level in front of the cabinet. Place the ends of the slides attached to the drawers into the tracks inside the cabinet. Pressing evenly on each side of the drawer, slide the drawer into place. The first slide inward can sometimes push a bit tougher, but once the tracks are engaged, the drawer should slide back out and in smoothly.

How-to-Install-Drawer-Slides---Step-8-copy

8. Position the Drawer Face

Apply wood glue to the face of the drawer box. With the drawer closed, position the drawer face with equal gaps along the top and side edges. Using clamps, secure the drawer face against the drawer box.

How-to-Install-Drawer-Slides---Step-9-copy

9. Attach the Drawer Face 

Carefully slide the drawer open, and then drive 1-inch screws through the holes in the drawer box and into the backside of the drawer face to secure it in place.

How-to-Install-Drawer-Slides---Step-10-copy

Leave a Comment